A Robotic Elevator using Lego & Arduino – Part2


In the first part of this series, we introduced the core structure of our elevator. But, we aren’t done yet with the mechanics. As shown in Video 1, our initial design was unbalanced. It isn’t usable at all to lift any weight, such as a smartphone. The solution is to lower and move back the center of gravity by adding extra weight at the rear (See Pictures 1 and 2).

This ends the mechanical structure of our elevator. In the next part, we’ll be discussing the electronics. We’ll show how to drive lego motors using an Arduino board.


Video 1: Balancing the Lego Elevator

wpid-elevatorV4-front-2013-12-9-16-31.jpg

Picture 1: Elevator Mechanical Structure V4 – Front View

wpid-elevatorV4-rear-2013-12-9-16-31.jpg

Picture 2: Elevator Mechanical Structure V4 – Rear View

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.